Late drilling of cereals this year has been inevitable after the challenges of a very wet autumn and winter.

In general, though, Scotland’s winter barley crops went in before the weather broke and are looking relatively well, despite saturated soils.

Winter wheat is a totally different story and crops, where drilling was delayed by wet weather until late October or later, have commonly struggled with emergence, often looking very poor and with seed rotting in the drills.

Wheat drilling has continued into the new year where ground conditions have allowed, but the crop protection needs of late drilled crops are very different to those of early drilled crops.

SRUC trials conducted as part of an AHDB project on wheat agronomy, show that delaying drilling for a month has the broadly the same reduction on septoria levels as drilling a susceptible ‘4-rated’ variety, versus a resistant variety rated 8.

That gives plenty of scope to reduce early inputs to the late drilled crop, which probably aligns with a more reduced yield potential. The need for a T0 spray timed for before the first application targeted at leaf 3 emerging (T3) is very reduced in a late drilled scenario.

One reason for a T0 might be to manage mildew, although with the reduction in the susceptible variety, Leeds, in Scottish acreages there are fewer reports of mildew this year.

Yellow rust is another reason why a T0 might be justified, but with less winter crop in the ground and few early reports, even south of the Border, the risk is probably lower this year than most.

Stem base disease risks are another factor reduced by late drilling and this might allow for further rationalisation of T1 inputs where, commonly, SDHI and prothioconazole actives have helped to manage the risk from eyespot. If eyespot is less of a risk then reducing rates or taking out the SDHI component might be an option if other disease risks allow.

In winter barley, the overwintering issues can be various and include rhynchosporium, net blotch and mildew. Crops to date seem fairly clean, but if disease does get established then it can be hard to nail at the main T1 timing aimed at the start of stem extension and an early spray at mid-tillering could be justified.

If early disease is highlighted from crop walking, then a T0 spray using different fungicide groups to those intended for later in the season is a sensible approach to reduce the risk of fungicide resistance in your later chemistry.

Tailoring fungicides to suit the seasonal risks and the drilling dates of crops is very much part of an Integrated Pest Management approach – and a plus when you fill in your in-line IPM plan at https://www.fas.scot/environment/biodiversity/integrated-pest-management/